026 – 73 AddFlow 026-UK V1.
1. Connections table Description Carrier flowmeter Connection Supply Signal Ground Supply 12 V S2 ╧ 12 V (Brown) Liquid flow sensor Signal S4 (Black) Ground ╧ (Blue) Supply Master signal (12V is spraying) 12 V (Brown) Signal S5 (Black) Jumpers J7 J9 J8 026-UK V1.
2. Generalities Function Key Description The unit will power on and show the first working screen 1. Power on 2. Power off 3. Selection of working screen 026-UK V1.01 Pro ↑ ↑ and ↓ Inj . r at e 2.
3. Functionality Function 1. Injection dose rate 2. Injection flow 3. Carrier flow 4. Injected volume Display Comments Possible actions Inj . r at e 2.00 % This is the desired dose rate for the injected product. It is set as a percentage of the main carrier flow. Pro to change dose rate inj . f l ow 0.
. Alarms Function 1. Pump not running 2. No liquid injected 026-UK V1.01 Display Pump st opped Inj . Tank empt y Comments Alarm message will appear when injection started but the pump is not turning This means that no liquid is injected. Alarm message will appear only if the liquid presence sensor is mounted. 18/05/2006 Possible actions Check cabling and pump Check plumbing and/or fill the tank.
. Program Function Access / Exit 1. Carrier flowmeter Display Car . f l ow set up Possible actions Push Pro for 3 seconds Comments Master must be off ↓ to select another step Pro to enter carrier flowmeter calibration (1.1) Push Pro for 3 seconds to escape program 1.1 2. Injection pump Car . f l ow 150 p/ l Inj . pump set up ↑ ↓ to modify value Main carrier flowmeter calibration in pulses/lt Pro to validate value ↑ ↓ to select another step Pro to enter calibration (2.
. Pump autocalibration Function 2.2 Injection pump calibration Display Inj . pump 6.00 Possible actions ↑ ↓ to modify value Pro to validate value (2) CLR to start Autocalibration 2.2.1 2.2.2 2.2.3 St ar t aut ocal St ar t 235 p inj . vol 0.000 l CLR to exit Autocalibration Push on the CAL switch on the pump to start the calibration. Collect the pumped volume. Keep the CAL switch pushed until calibration is finished Display shows the counted pulses from the pump.
026-UK V1.
