User's Manual

WM5347N User Manual
78
9. WiMAX
This technology is based on the IEEE 802.16 standard, enabling the delivery of last mile wireless
broadband access.
9.1. Profile
In the profile tab, the user can set WiMAX standard settings, which include how to establish a
connection, frequency information and how to authenticate.
9.1.1. Connect Settings
“WiMAX>Profile>Connect Settings”
Name Description
Auto Reconnect Indicate the interval in second to “auto reconnect”. 0
means disabled.
Auto connect Mode Connecting base on CINR or RSSI to connect the best
signal.
NDS Mode Enable NDS mode.
NDS Network
Parameters File
Upload NDS Network Parameters File.
Enable Handover Enable Handover.
Enable Idle Mode Enable Idle mode.
Idle Mode Interval The time interval of idle mode.
CINR & RSSI
Refresh Interval
Refresh time interval of CINR & RSSI.
LDRP Time LDRP (Low Data Rate Protection). When it’s enabled, if
the uplink/downlink data rate is smaller than the LDRP
time, the CPE will send disconnect command to BS.
LDRP TX/RX Rate LDRP uplink/downlink data rate.
Search Click on the search button to search for available BSIDs.
Connect Mode Select a connect mode
 Auto Connect Mode: It will connect to one of the BSIDs
in the list, indiscriminately.
 Network Search Mode: User needs to select one of the
BSIDs from the list, it will use that BSID to connect to
WiMAX after device is reboot.