KRD 901 54 Quick Installation Guide Home Base Station 2 Mobile@Home
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Disclaimer The contents of this document are subject to revision without notice due to continued progress in methodology, design, and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document. Introduction This guide describes briefly how to install the KRD 901 54 access point (AP) and how to pair/bond this to the Mobile Phone.
they will influence the transmitted signals. Usually the antenna is recommended to point vertically. Figure 2 Wall mount. Front view to the left. Bottom view to the right.
Cabling of Power Connections To connect the KRD 901 54 the power adapter enclosed is to be used. If Power over Ethernet is available this may be used instead of powering via the power adapter cable. The power cable and the Ethernet cable to the IP Access Network shall be connected as shown in Figure 4 below. Buttons on rear panel of KRD 901 54 On the rear panel a push-button is placed. Pressing the button once will start the member pairing sequence.
LED indications of KRD 901 54 On the front of the KRD 901 54 four Light Emitting Diodes (LEDs) are situated. The LEDs gives indications as described in the Table 1 below. The LEDs labeled Member and Guest are only used in relation to the pairing sequence and will be turned off after a short time. Pairing mode lasts 2 minutes from the pairing button is pressed.
Registering a Mobile Phone to the KRD 901 54 – Pairing In order to make the first call through the KRD 901 54, the Mobile Phone has to be registered to the KRD 901 54 – the so-called pairing or bonding. After a reset i.e. activation of the Reset button, it is necessary to redo the pairing. The Mobile Phone must be Bluetooth enabled. Please refer to instructions regarding “Bluetooth wireless” in the user’s guide of the actual Mobile Phone in use. Pairing can take place in two cases.
Bluetooth devices that are located within the range of the Mobile Phone will be listed in the display. KRD 901 54 devices are identified by their Bluetooth Device Address that can also be found on the bar code label (BDA). The information displayed in the list is vendor dependant. Depending on the service provider a PIN code may be requested for security reasons. This will be prompted for in the display.
Ericsson Telecom AB www.ericsson.
