User's Manual

Administrative Guide Appendix 1

WDS support

Configuration Management

 LAN/WAN management via Telnet interface or Web-based browser interface

 Firmware upgrade available by TFTP/ HTTP

 Status display and event report from Web-based management

 Settings Save and Restore

 Reset to factory default

Radio - WLAN

 Stansard : IEEE 802.1g and 802.11b

 Media Access Control : CSMA/CA with ACK

 Modulation : OFDM/CCK

 Frequency Range (Range depends on different country)

 Output Power : 15dBm (typical)

 Sensitivity : -67 (54Mbps) / -83 (11Mbps) dBm (typical)

 Data Rate : 54, 48, 36, 24, 18, 12, 11, 6, 5.5, 2, 1Mbps, auto-fallback

Remote Diagnostic

 Syslog

 Device Diagnostic, Enable remote test following:

Test the connection to your local network,

The connection to your Internet service provider,

The status of PSTN Line,

The status of IP Trunk Line,

The status of VAA Line,

The status of FXS

The registered status of SIP Phones

Physical Interfaces

 One 10/100BaseT Internet port (RJ-45) for WAN interface

 Four 10/100BaseT Internet port (RJ-45) for LAN interface

 One Telephone interface (RJ-11)

 Three PSTN Line interface

 One PSTN Backup line

LED Status

LED Name Color Status Description

On Power on. POWER Blue

Off Power off.

On Wireless LAN initialization success. WIRELESS Blue

Off Wireless LAN is not present.

Off PSTN Line is idle. LINE (1-3) Blue

On PSTN Line is busy.

Off Phone is idle. TEL Blue

On Phone is busy.

ETHERNET(1-4) Blue On LAN connected.