User's Manual
TECOM CO., LTD. TECOM Bluetooth Access Point PROJECT
Prepared by: CPE-U1 Internal Document
[Product Revision Information] Page Revision Date Issued
User's Manual 7(4) 0.1 08-30-2002
Figure 5 Network page on the Web Interface
3.1.4. Advanced Setup without DHCP
When Bluetooth Access Point is powered up, it automatically looks for a DHCP server
in the network to get an IP address for itself so that the Access Point is ready to use
without user intervention. However, if there is no DHCP server in the environment,
Bluetooth Access Point will reset to its factory default static IP address 192.168.1.120,
and will require manual setup for your network.
Note: If your network already uses the non-routable 192.168.1.X with the 192.168.1.1
Gateway Address, and if 192.168.1.120 is not taken by other elements in the network,
you do not necessarily need to change any settings. Your Access Point will work
immediately.
The quickest way to change the IP Address of the Access Point is through the Locator
utility. Simply connect the Access Point to your PC through a cross-over CAT5
Ethernet cable (or connect both Bluetooth Access Point and your PC to a hub through
normal Ethernet cables). Running Locator will enable you to discover the Access Point
immediately without a need to adjust the PCs subnet to that of the Access Point’s.
Then you can highlight the discovered Access Point and hit the Configure button to
manually set the network parameters for the Access Point through the Use the
Following IP Address section. Please refer to the Locatorâ„¢ Management and
Configuration section for more information.