User's Manual

TECOM CO., LTD.
23, R&D ROAD 2, SBIP
HSIN-CHU, TAIWAN, ROC
PHONE: [phone]
FAX: [phone]
Subject: Quick System Setup and Reference Guide for Cordless DK Telephone System Date: Jul. 23, 2004
Author: SOHO Department, CPE R&D Division, TECOM Revision: 03
Email: [e-mail] Page:4/26
I. Introduction
The cordless DK EKT system must connect to the Tecom DK System. It will provide powerful and
convenient cordless function for business user.
There are 2 EKT lines from KSU to the base in the cordless system. If the handset ID is #1, it
means the handset is connected to the Line#1. If the handset ID is #2, it means the handset is
connected to the Line#2.
The system also provides simply setup function to install the cordless system easily.
User just presses and holds the [F1] key over 1 second. The system will automatically enter the
System Programming mode. It will allow users to set up the system and more friendly function.
And, the LCD will display:
When user enters the [System Programming Mode], all [Soft keys] will be changed the following
programming function key:
[F1] key: [DOWN] key.
[F2] key: [UP] key.
[F3] key: [OK] key.
[Hold] key: [EXIT] key.
User can use the above programming function keys to set up your powerful cordless system.
There are 3 different LED flash cadence for user’s reference.
(1) Normal Operation: LED Flash [Normally]: 500ms on, 500ms off, repeatedly.
In normal mode, users can make/receive a cal by the handset unit through the base unit.
(2) Base is in transition mode: LED Flash [Slowly]: 1000ms on, 1000ms off, repeatedly.
In the transition mode, user is changing the DIP switches status. The system will wait for 5
>LANGUAGE
REGISTRATION