User's Manual

TECOM CO., LTD.
23, R&D ROAD 2, SBIP
HSIN-CHU, TAIWAN, ROC
PHONE: [phone]
FAX: [phone]
Subject: Quick System Setup and Reference Guide for Cordless DK Telephone System Date: Jul. 23, 2004
Author: SOHO Department, CPE R&D Division, TECOM Revision: 03
Email: [e-mail] Page:17/26
Press [F3] (the same as [OK] key) to confirm, the LCD will display: (e.g. [YES])
If the de-registration is successful, the LCD will display:
If the de-registration fails after about 20-30 seconds, the Handset LCD will display:
Note:
1. The base doesn’t need to enter the de-registration mode. And, the system must be in idle mode.
2. Only one handset can de-register to the base at a time.
3. The handset can register to the other base without de-registration to the original base. But the
original base will keep the handset information forever.
4. About the registration operation, please check Registration or Installation section.
4. Vibration Programming
There are 3 modes for [Vibration] programming mode.
The select item: RING, VIBRATOR, RING + VIB. Default: RING.
Standby, press and hold the [F1] key over 1 second to enter the [PROGRAM MODE] and then
select the corresponding item.
The LCD will display:
(( ))
DE-REGISTERING.
PLEASE WAIT!
(( ))
DE-REGISTER
OK!
(( ))
FAILED!
TRY AGAIN!