User Manual

VTECH TELECOMMUNICATIONS LTD.
File :VT40-2421
MMI REV 4.doc
Date : 15 Nov, 2000 TITLE : INTERNAL PRODUCT SPECIFICATION
DOCUMENT NO.
VT40-2421 MMI REV NO.
4
PAGE
8 of 43
5. FUNCTIONAL DESCRIPTION OF HANDSET AND BASE
5.1. HANDSET
5.1.1. DIALING KEYS “0~9”, “*” & “#”
Press the dial digits 0~9, “*” or “#’ on the dialing keypad. The corresponding DTMF
tone (or pulse sequence) will be dialed out immediately. The dial digits will be
buffered up to 30 digits maximum. If the digit you entered faster than the phone
dialing, all the digits will dialed out in sequentially.
The ‘#’ key will be ignored if in pulse dialing mode.
In pulse dialing mode. The “*” key is temporarily used for enable tone dialing mode.
5.1.2. LINE KEYS
Pressed the [Lx] key, where x=1,2,3,4 you can hear a dial tone on the Earpiece for
placing an outside call or retrieving a line on hold.
5.1.3. END KEY
You can press the [END] key to ending a call and to quit all modes.
5.1.4. INTERCOM KEY
Press the [INTERCOM] key to initiate / confirm two-way internal communication
between the handsets. To exit the intercom mode by presses the [END] key on the
Handset.
5.1.5. REDIAL KEY
Press the [Lx] key, where x=1,2,3,4 and then Press [REDIAL] to redial the last dialed
number.
or
Press [REDIAL] key to display the last dialed number and then press an available
[Lx] key, where x=1,2,3,4 to automatically dial out the last dialed number.
5.1.6. CID LIST KEY
Press the [CID LIST] key to retrieve CID database.
5.1.7. FLASH KEY
Press [FLASH] key to activate call waiting or 3-way calling.
5.1.8. HOLD KEY
Press the [HOLD] key to place the call on hold. You can then,