Operation Manual

14
COMPARTMENT, DRAWER & RACK MAINTENANCE
Please be careful when handling and removing comparments, drawers
and racks. Follow the steps below to remove, clean and replace each of
the refrigerator items.
CHILL ZONE
It is necessary to remove the chill zone cover before removing the drawer.
Pull the cover out while tilting up on the left side. Continue to pull the cover
out gently to remove completely. Refer to Fig. 1 below.
Once the cover is removed, the chill zone campartment can be removed
by gently pulling the compartment forward until fully extended. Lift the
drawer slightly while continuing to pull forward. The drawer should lift past
the mechanisim keeping it on the drawer rail. Remove the compartment
and clean the drawer and cover thoroughly. Alow to dry completely before
returning to original position.
To replace, fi rst install the chill zone compartment. To do so, install by
tilting the drawer back and into the rails. Once the rear of the drawer
is correctly on the rail, lower and slide the chill zone drawer back into
position.
Replace the chill zone lid by tilting to the left and sliding into position.
Fig. 3
Fig. 1
Fig. 4
Fig. 2
GLASS SHELVES & DOOR RACKS
To remove glass shelves for cleaning, pull the shelf out as far as possible
and then lift slightly. The shelf should lift away easily. (Refer to Fig. 3).
Clean the shelf completely, alow to dry before replacing.
To remove the door racks, grasp the rack with both hands and gently lift.
Once removed, clean and alow to dry before replacing. (Refer to Fig. 4).