User Manual

HEATER INSTALLATION GUIDE

STEP 4

Plug in and turn on the chiller 1

Find the circuit board on the top of the electronic housing. 2

Remove the plastic “jumper” from prongs 4 and 5 (See

Diagram Below).

Place jumper on pins 7&8, this will reset your chiller. 3

Remove jumper from pins 7&8. 4

Now turn off your chiller. 5

CAUTION: Leaving chiller on with no water flowing will 6

cause the unit to overheat.

Place Jumper over pins 5&6 7

Note: Resting your chiller will change your set temperature 8

to the default of 77.

Re-connect the green ground cable, replace housing. Your 9

Chiller’s heater is now installed.

No Heater or UV

Heater and UV Installed

Heater Installed

UV Installed

Heater

Jumper

Reset

Jumper