User`s manual

;-#<
UPS EVO DSP PLUS TT  User’s manual
Following pages shows LCD display for operating modes and status.
If the UPS is in normal operation, it will show seven screens one by one, which represents 3 Phase Input/Output
voltages (;, ;, .;), 3 Line Input/Output voltages (, ., .) and frequency in turns (see the table below).
!!!  !
L1 PhaseNeutral Voltage (Input/Output)
L2 PhaseNeutral Voltage (Input/Output)
L3 PhaseNeutral Voltage (Input/Output)
L1 PhaseL2 Phase Voltage (Input/Output)
L2 PhaseL3 Phase Voltage (Input/Output)
L3 PhaseL1 Phase Voltage (Input/Output)
 Frequency (Input/Output)
Parallel UPS Systems, “001” means the master UPS
If Parallel UPS Systems are successfully set up, it will
show one more screen with “/”.
The master UPS will be default assigned as “” and
slave UPSs will be assigned as either “002” or “003”.
The assigned numbers may be changed dynamically in
the operation
!!,
0) 
When UPS is powered on, it will enter into this mode for a few seconds as initializing the CPU and system.
All the icons on the graphic LCD panel are ON.
All the leds are ON.