User`s manual
;-#<
User’s manual UPS EVO DSP PLUS TT
The following table shows the recommended size for Input, Output and Battery wires.
"$
+',B,,C
#
(!
(!
;! 7! -$
6 mm
2
6 mm
2
8 mm
2
10 mm
2
10 mm
2
8 mm
2
8 mm
2
10 mm
2
10 mm
2
10 mm
2
8 mm
2
8 mm
2
10 mm
2
10 mm
2
10 mm
2
16 mm
2
16 mm
2
16 mm
2
10 mm
2
16 mm
2
;#;?*!*!$**,,, $$!!,!((
,,A!(,>(!(,*$(6!)
+, $'*%/#&/,!)(*'$,!=
$**, 6(* !')
+, $$$,!.#D*()
1) #!!
.,(-/;*( !>',,),,(-/;
!( !>'$,,)
"!>(!(!,,$'(( !)
We advise you to follow the steps below explained:
) Remove the !,!(!,6(#D !, see figure 4. The terminals are shown in
figure 5. All the cables have to reach the terminals from the rear side using the proper holes in the metallic
panel.
) Connect the #; paying attention to the right polarity, in accordance with figure 5, as explained
below:
Connect INPUT GROUND wire to the INPUT GND screw.
Connect INPUT LINE L1 phase wire to the INPUT L1 terminal (#5).
Connect INPUT LINE L2 phase wire to the INPUT L2 terminal (#6).
Connect INPUT LINE L3 phase wire to the INPUT L3 terminal (#7).
Connect INPUT NEUTRAL wire to the INPUT N terminal (#8).
) Connect the paying attention to the right polarity, in accordance with figure 5, as explained
below:
Connect OUTPUT GROUND wire to the OUTPUT GND screw.
Connect OUTPUT LINE L1 phase wire to the OUTPUT L1 terminal (#1).
Connect OUTPUT LINE L2 phase wire to the OUTPUT L2 terminal (#2).
Connect OUTPUT LINE L3 phase wire to the OUTPUT L3 terminal (#3).
Connect OUTPUT NEUTRAL wire to the OUTPUT N terminal (#4).