User`s manual

;-#<
UPS EVO DSP PLUS TT 3 User’s manual
The Battery mode is identified by:
1. 7! led is ON.
2. The graphic LCD panel shows the path of energy
flow during Battery mode.
3. An acoustic signal every 4 seconds.
0)0 7F"$
In Bypass mode, the AC Input line is directly connected with the UPS outlets by an Automatic Bypass.
As indicated in figure 1, in Bypass mode the UPS recharges the batteries.
If you connect the AC Input line to the UPS and the Input line breaker on the rear is “ON”, the UPS will go to
Bypass mode.
The Bypass mode is an idle mode for the UPS: then by pressing ; button, the UPS turns ON completely,
activating the Inverter block.
When the UPS works in Bypass mode it can be considered as “not active”, since the Inverter block is not active.
The UPS is considered “active” when the Inverter block is ON (in Normal mode and in Battery mode).
Furthermore the UPS ,( ! !,!  7! $ ! ! ,A, * !,,$! 6!$ 
#6*!(,'($$6,)