Explosion diagram specification 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 TP+LCM SEAL MYLAR PROXIMITY SENSOR RUBBER REAR_CAM_SUPPORT_CON R MAIN CAM CON FOAMS SPEAKER MAIN WATERPROOF FRAME SPK CONDUCTIVE FABRIC 8W CAMERA RUBBER MAIN RADIATING FILM NFC R FLASH LENS SCREW M1.4 L2.5 SCREW M1.4 L3.
Know your phone 1. Front camera 2. Volume + key 3. Volume - key 4. Power key & side fingerprint sensor 5.
SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation.
Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. SAR Information Statement Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 1.128W/Kg and when worn on the body, as described in this user guide, is 0.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.
HiOS runs on AndroidTM OS. Android is a trademark of Google LLC.
