Explosion diagram specification 1 3 5 7 9 11 13 FL(CTP+LCM) 6.52HD+ KE5 Black HX V1.0 FPC Side key BB4 2 Shield Seal Cop foil 20.7*15.5 *0.06 KE5 F CAM Seal rubber KE5 Black FM(ICNF7332AL)04 Aqua Blue19 fingerchip CAM AF 13M S5K3L6 B B 5P B ST V1.0 F CAM con fb 10.75*7.75*0.1 KE5 6 4 8 10 12 14 Astigmatism film 3.5*1.2*0.05 KE5 Astigmatism film 3.5*1.2*0.05 KE5 LT sensor Seal rubber KE5 Black FPC REC KC1 CAM FF 8W GC6153 CSP W6003 XCG V_1.0 CAM FF 8M GC8034 A B 4P B TXD V1.
15 16 25 F LED-Flashseal mylar 8*4.8*0.03 KE5 REC 1206W H20 broadband H:SPL 50mW Goer BATT Seal rubber 6.15*4.0*0.65 KE5 R hsg asm KE5 Black PC R CAM lens KE5 Glass 0.5mm Black Bat cover asm KE5 Aqua Blue PC 27 SPK frame asm KE5 Black PC 28 29 Bat TECNO BL 49FT 4900mAh FH IN FP graphite film 37.14*28.8 *0.05 KE5 FP support foam 13.26*12.78 *0.6 KE5 ZIF mylar 9.5*3.5*0.05 KE5 SPK 1115 SPR H3.0 aluminiumfilmRoHS Goer FPC SPK KE5 30 PCBA MB H6123 A1 32GB+2GB V1.0 R MAIN CAM Con foams 12.61*10.46*0.
Know your phone 1. Front camera 2. Volume key 3.
SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation.
Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). 1. Please remind the front and back of the plug. 2. Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.