Explosion diagram specification 1 2 9 Card Holder asm CG7 Magnet Black R hsg Seal Mylar 19.71*7.94 CG7 RCAM LensCG7KN3 41.56 *10.36*0.5DarChrome mc screw M1.4*L2.0*D3.0 *H0.5 silver glue R hsg asm CG7 Magnet Black 11 R CAM Rubber 2M X693 Black 12 13 CAM FF 2M GC02M1B YM P 3P+IR B SJ V1.0 CAM FF 2M GC02M1 A P 3P+IR B LHYX V1.0 R CAM Frame CG7 14 3 5 7 15 17 4 6 8 10 16 18 Bat cover asm CG7 Magnet Black UP Frame Radiating fin 60.5 *58.51 CG7 mc screw M1.4*L3.0*D2.5 *H0.
19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 CAM FF 16M S5K3P9SP04 A B 5P B TS V1.0 Distance Sensor Rubber X693 Black R CAM BTBWaterproof Rubber 8W5.9*3.92CG7 F CAM Con fb 12.01*5 CG7 REC 0809W H20 shrapnel 50mW 123dB Goer F hsg asm CG7 Black FL(CTP+LCM) 6.78FHD+ H CG7 Black TM V1.0 MAIN Radiating Film 37*55.6 CG7 Bat CONN Rubber 15.66*4.18 X693 Black FPC MAIN CG7 Bat TECNO BL 49GT 4900mAh ATL IN FM(GSL6157) 0821 Black finger chip SPK 1115 SPR H2.5 1.0W HS USB Rubber CG7 Black SPK Frame Seal Mylar 22.
1. Front camera 2. Volume key 3. Power key SIM/SD card installation 1. Power off mobile.
2. Refer to the following picture for SIM / SD card installation.
to the computer using a USB cable (comes with the phone). 1. Please remind the front and back of the plug. 2. Use only TECNO charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty. FCC Statement 1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bands.
of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.
Android is a trademark of Google LLC.