Instructions

CARE AND MAINTENANCE
Remove the plug from the socket before carrying out any adjustment,
Servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. Always store your power tool in a dry
place. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
If a fault can not be rectified, return the mixer to an authorized dealer for repair.
Cleaning
- Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as possible. Clean
the unit by rubbing it with a clean cloth or blow it clean using low-pressure compressed air.
- We recommend that you always clean the unit immediately after using it.
- Clean the unit regularly by rubbing it with a damp cloth and a little soft soap. Do not use cleaners or
solvents; these will attack the plastic parts in the unit. You must also ensure that water cannot get into
the inside of the unit.
Carbon brushes
- If excessive sparking occurs you must have the carbon brushes checked by a qualified electrician.
Attention! Only a qualified electrician is allowed to change the brushes.
CORRECTIVE ACTION IN CASE OF FAILURE
(1) The operating switch is switched on, but the motor is not working.
- Wires in the mains plug or in the socket are loose.
Have socket and plug checked or repaired.
- The switch is faulty.
Have the switch replaced.
(2) The operating switch is switched on, but unusual noises can be heard, the motor is not working or only
very slowly.
- Switch contact has failed.
Have the switch replaced.
- Component jammed.
Have the electric tool checked or repaired.
- Too much thrust, as a result the motor is dragging.
Use less thrust during the task.
(3) Motor gets hot.
- Foreign substances have got inside the motor.
Have the foreign substances removed.
- Lack of or contaminated lubrication grease.
Have lubricating grease applied or replaced.
- Pressure too high
Use less thrust during the task
(4) Frequent or strong sparks on the commutator.
- Short circuit on the armature.
Have the armature replaced.
- Carbon brushes worn out or jammed
Have the carbon brushes checked.
- Rough running of the commutator.
Have the surface of the commutator cleaned or ground.
For your own safety, never remove parts or accessories of the electric tool during operation. In case of fault or
damage have the electric tool repaired only by a specialist workshop or by the manufacturer.