Instructions

Operate the machine with short length in narrow and awkward area.
Run the machine with medium length for higher walls.
Use the machine with longest length for ceilings.
- Do not over-press machine so that to avoid overloading! Press with proper pressure for better grinding
effects. Good grinding effects and quality are mainly decided by choosing the right abrasive material.
- Once finishing the sanding task, switch off the machine.
Switching on the unit
Hold the unit by the handles with both hands.
Push the on/off switch (G) forward. The unit starts.
Switching off the unit
Press the on/off switch (G) at the rear end downwards. Device stops.
Set speed
The speed regulator (M) allows the speed to be
infinitely variable adjustment of the speed.
Set the speed by adjusting the
adjust the speed regulator (M).
Extending the device
Open the fixation (N).
If necessary, pull suction hose out of fixation.
Insert extension (O) into fixation (N).