Instructions

Mounting the grinding sheets
- Place the grinding sheet (S) centrally on the
- Place the grinding plate (D) and screw tight (R).
- The grinding sheet is provided with a fleece on the underside.
- The Velcro fastener on the grinding plate the grinding sheet is fixed in place.
Operation
Check before switching on!
Check the safe condition of the device:
Check whether there are any visible defects.
Check whether all parts of the device are firmly mounted.
Attention:
Only install the specified grinding pad on the machine. In order to ensure optimal performance, machine
should be run at slightly lower speed for several minutes to make the grinding pad fit the sealing surface
perfectly. During this process, the white foam particles will come out from the grinding head. However,
this won’t damage the machine.
Connect to Vacuum Cleaner
Inhalation of dust is hazardous to health! When carrying out the work that can produce dust, please always
wear a dust mask.
● Loose the fastening nut.
● Connect the hose to the exit of the handle
● The other end of the hose is connected to the vacuum cleaner;
Operate the Machine
- Do not control the machine’s head.
- Hold the machine with both hands.
- Before operating the machine, make sure every fastening handle is closed.
- Connect the machine to the main power supply.
- Before switching on the machine, keep the sanding head slightly away from the work surface.
- Start the machine for necessary sanding work.
Operate the machine with short length in narrow and awkward area.
Run the machine with medium length for higher walls.
Use the machine with longest length for ceilings.
- Do not over-press machine so that to avoid overloading! Press with proper pressure for better grinding
effects. Good grinding effects and quality are mainly decided by choosing the right abrasive material.
- Once finishing the sanding task, switch off the machine.