User Guide

TROUBLESHOOTING
To determine any problem with your CD changer, always check the most obvious possible causes first. If any problem still
remains after you have checked the items below, consult your nearest TECHWOOD dealer.
Problem Probable Cause Remedy
No power when the POWER button is
set to ON.
Power plug not connected in the AC
outlet.
Insert the power plug firmly into the AC
outlet.
The disc is loaded upside down. Reload the disc with the label side up.Disc play does not start.
The disc is too dirty. Clean the disc.
Incorrect audio cable connections. Correctly connect the CD changer to
the amplifier.
No sound.
Incorrect amplifier operation. Make sure that the amplifier controls
are set correctly.
The CD changer is subject to vibration
or physical shock.
Change the installation location.Sound skips.
Defective or deeply scratched disc. Play another disc.
Programmed play does not function. The CD changer is in the normal play
mode.
Press the stop button, then enter a pro-
gram.
A “Hum” sound can be heard. Loose cable connections. Firmly connect all the cables.
11