TECHVIEW Adaptador inalambrico USB de 300 Mbps : User's Manual : Page 34

User Guide

-31-

then switch to AP mode.

Q5: Client cannot obtain IP when connected to soft AP of the wireless network adapter.

A5: Manually set an IP address at the same net segment as that of AP and the gateway at the IP

address of AP. And communication can be achieved.

Q6: Some function buttons on UI become grey and can not be used.

A6: This is because you have switched to Zero config mode, please right click the Wilink UI ON the

right-down corner of your desktop. Operations can be done after you have switched to Wilink UI.