Datasheet

Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Commission Regulation (EU)
2015/830
1610-50PK Isopropyl Alcohol Wipes
SECTION 7: Handling and storage
Keep container in a cool, well-ventilated area.
Advice on general
occupational hygiene
:
7.2 Conditions for safe storage, including any incompatibilities
7.3 Specific end use(s)
Recommendations
:
:
Industrial sector specific
solutions
Not available.
Not available.
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before
eating, drinking and smoking. Remove contaminated clothing and protective
equipment before entering eating areas. See also Section 8 for additional
information on hygiene measures.
Seveso Directive - Reporting thresholds (in tonnes)
Danger criteria
Category
P5c: Flammable liquids 2 and 3 not falling under P5a or P5b
5000
50000
Notification and MAPP
threshold
Safety report threshold
Recommended monitoring
procedures
If this product contains ingredients with exposure limits, personal, workplace
atmosphere or biological monitoring may be required to determine the effectiveness
of the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to monitoring standards, such as
the following: European Standard EN 689 (Workplace atmospheres - Guidance for
the assessment of exposure by inhalation to chemical agents for comparison with
limit values and measurement strategy) European Standard EN 14042 (Workplace
atmospheres - Guide for the application and use of procedures for the assessment
of exposure to chemical and biological agents) European Standard EN 482
(Workplace atmospheres - General requirements for the performance of procedures
for the measurement of chemical agents) Reference to national guidance
documents for methods for the determination of hazardous substances will also be
required.
:
Appropriate engineering
controls
:
Use only with adequate ventilation. Use process enclosures, local exhaust
ventilation or other engineering controls to keep worker exposure to airborne
contaminants below any recommended or statutory limits. The engineering
controls also need to keep gas, vapour or dust concentrations below any lower
explosive limits. Use explosion-proof ventilation equipment.
8.2 Exposure controls
No DNELs/DMELs available.
PNECs
No PNECs available
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
DNELs/DMELs
Individual protection measures
The information in this section contains generic advice and guidance. Information is provided based on typical
anticipated uses of the product. Additional measures might be required for bulk handling or other uses that could
significantly increase worker exposure or environmental releases.
Occupational exposure limits
No exposure limit value known.
Date of issue/Date of revision
:
9/6/2016
Date of previous issue
:
No previous validation
Version
:
1
6/13