Datasheet

Conforms to Regulation (EC) No. 1907/2006 (REACH), Annex II, as amended by Commission Regulation (EU)
2015/830
Techspray Eco-Oven
SECTION 8: Exposure controls/personal protection
Hand protection
Based on the hazard and potential for exposure, select a respirator that meets the
appropriate standard or certification. Respirators must be used according to a
respiratory protection program to ensure proper fitting, training, and other important
aspects of use.
Chemical-resistant, impervious gloves complying with an approved standard should
be worn at all times when handling chemical products if a risk assessment indicates
this is necessary. Considering the parameters specified by the glove manufacturer,
check during use that the gloves are still retaining their protective properties. It
should be noted that the time to breakthrough for any glove material may be
different for different glove manufacturers. In the case of mixtures, consisting of
several substances, the protection time of the gloves cannot be accurately
estimated.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn,
unless the assessment indicates a higher degree of protection: chemical splash
goggles and/or face shield. If inhalation hazards exist, a full-face respirator may be
required instead.
Eye/face protection
Respiratory protection
:
:
:
Skin protection
Personal protective equipment for the body should be selected based on the task
being performed and the risks involved and should be approved by a specialist
before handling this product.
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to
ensure they comply with the requirements of environmental protection legislation.
In some cases, fume scrubbers, filters or engineering modifications to the process
equipment will be necessary to reduce emissions to acceptable levels.
Body protection
:
Other skin protection
Appropriate footwear and any additional skin protection measures should be
selected based on the task being performed and the risks involved and should be
approved by a specialist before handling this product.
100°C
Physical state
Melting point/freezing point
Initial boiling point and
boiling range
Vapour pressure
Relative density
Vapour density
Solubility(ies)
Liquid.
Not available.
1
Not available.
0.0027 kPa [room temperature]
Not available.
Not available.
Odour
pH
Clear.
Colour
Evaporation rate
Not available.
Auto-ignition temperature
Flash point
Not available.
Closed cup: Not applicable. [Tagliabue.]
Not available.
Not available.
10.5
Not available.
Odour threshold
Partition coefficient: n-octanol/
water
Upper/lower flammability or
explosive limits
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
9.1 Information on basic physical and chemical properties
Appearance
Decomposition temperature
:
Not available.
SECTION 9: Physical and chemical properties
Flammability (solid, gas)
:
Not available.
Date of issue/Date of revision
:
5/11/2017
Date of previous issue
:
No previous validation
Version
:
1
7/13