Operation Manual

BROADBAND INTERNET ROUTER – USER’S MANUAL

- Page 4 of 13 -

C. Reset Button

While you forget the password to login the utility or want to re-configure it, press the

button to restore the factory default configuration. Press the button during 1~5seconds,

system will just restart. Press the button more than 5 seconds, system will restore

default config (default IP is 192.168.1.1)

Hardware

♦

4 LAN Ports

For linking computers or other Ethernet devices, e.g. a hub/switch

♦

WAN Port

For linking to the Ethernet port of a cable/DSL modem

♦

Power (3.3V/3A)

Used to connect the external power adapter supplied with the router. Note that

only the supplied adapter should be used.

Hardware Installation

Making a Connection

1. Connect to a cable/DSL modem -- Use a standard Ethernet RJ-45 cable

(Cross over).

Check the “Link/Act” LED of “WAN” port on front panel, it must be on.

2. Connect to the PCs – use a standard Ethernet RJ-45 Cable.

3. Connect the power adapter.



Attention:

1. The cable distance between the IP Sharing Router and PC/hub/Switch

should not exceed 100 meters.

2. Make sure the wiring is correct. In 10Mbps operation, Category 3/4/5 cable

can be used for connection. To reliably operate your network at 100Mbps,

you must use Category 5 cable, or better Data Grade.