Operation Manual

SnagIt 9.0 Help File PDF
www.techsmith.com  43
Setup Instructions
1. In SnagIt, select Image capture mode.
2. Select the Input and Output.
3. Select Effects down arrow > Color Substitution > Color Substitution. The Color Substitution task pane
appears.
4. Use the Old Color tool or the adjacent Color swatch to select the color to remove from the capture. (In example
above, white.)
5. Use the New Color tool or the adjacent Color swatch to select the color to replace the old color in the capture. (In
example above, green.)
6. Click Add to add another color to change. Repeat steps 4 and 5 for every color to change.
7. In Color accuracy, specify the range of colors close to the Old color to include in the substitution. Select the
default value of 100% to use only the exact color identified. Select a lower value to increase the range of colors
for the color substitution. (In example above, 77% because the image included white that had been anti-aliased.)
8. Click Close.
9. Click the Capture button or press the capture hotkey. The capture is sent to the selected Output.
To disable the Color Substitution Effect, select Effects down arrow > Color Substitution > None.
For additional effects, see Add an Effect during Image Capture.
Swap Colors Effect
Use the Color Substitution Effect to swap two colors with each other during the capture process.
You must select both the old and new colors from within the image. In this example, everything green was
swapped with red.