Use and Care Manual

ManualsBrandsTechOrbits ManualsDesks60 in. Black/White Electric Standing Desk with Adjustable Height and Memory Settings - Motorized Workstation

HANDSET LOCK

The handset can be locked to prevent accidental activation or movement of the desk and to prevent desk

settings from being accidentally changed by children or coworkers

TO LOCK: Press and hold the “ ” and” ” buttons simultaneously for 5 seconds until the LED reads “Loc”.

TO UNLOCK: Press and hold the “UP” and”Down” buttons simultaneously for 5 seconds until the LED switches

from “Loc” to the height display.

ADVANCED SETTING

Press the “ ” button for 5 seconds until the LED ashes. The menu contains 7 items as the table below.

Short press the “ ” button to select the item you’d like to set, then use the “ / ” buttons to adjust

the value. Long press the “ ” button to save the setting and a progress bar will appear. “SUS” will be

displayed if it is saved successfully, and “FAL” will be displayed if it fails. The menu will return to the display

height automatically if no operation within 10 seconds.

The setting value should be at least 10cm(39.”) less than

the Maximum Height

SETTING RANGE REMARKS

Minimum Height

63.0cm~119cm

(24.8”~46.9”)

The setting Value should be at least 10cm(3.9”) more than the

Minimum Height

Maximum Height

72.0cm~122cm

(28.3”~48”)

Increase the Starting Height to the current height rangeStarting Height

0.0~30.0cm

(11.8”)

0:shut down

1~5: The higher the number, the higher the sensitivity

Upward Anti-Collision

PC0~PC5

0:shout down

1~5: The higher the number, the higher the sensitivity

Downward Anti-Collision dC0~dC5

0:shout down

1~5: The higher the number, the higher the sensitivity

Sensor Anti-Collision

SS0~SS50

Change the numeric display to show heights in centimeters

Display Unit

U-0

Change the numeric display to show heights in inches

U-1

TROUBLESHOOTING

If your desk does not respond when you try to raise it or lower it, or if the handset displays error messages,

check to make sure all the cables are secure(Legs to cables, cables to Control box). If the problem persists,

perform the reset procedure below.

RESET PROCEDURE

Unplug the power cord and hold the “ ” button on the Handset for 30 seconds.

Plug the power cord back in.

Hold the “ “ button until the desk reaches its lowest height, then release. Hold the “ ” button

again for about 10 seconds until the desk lowers a bit more, then slightly rises and stops then release.