User's Manual

OPS-DRD USERS MANUAL
v2014-03-17
13 | P a g e
Port
Description
USB
Two (2) USB interface connectors, which provide complete Plug & Play
and hot swapping capability for up to 127 external devices. The USB
interface is compliant with USB UHCI, Rev. 2.0. The USB interface supports
Plug and Play, which enables you to connect or disconnect a device
without turning off the system.
LAN One (1) RJ-45 LAN interface connector, fully compliant with IEEE802.3u
10/100 Base-T CSMA/CD standards. The Ethernet port provides a standard
RJ-45 jack connector with LED indicators to show its Active/Link status and
speed status
W
L
AN
O
ne (1) SMA connector for attaching the provided WiFi antenna.
This port
supports 802.11b/g/n wireless standards.
SD
O
ne (1) standard SD Card Slot for installing additional flash storage.
SERVICE
This mini
-
USB port is for factory
service personnel. It is not intended for end
-
user
access.
Caution!
IMPROPER USE OF THIS PORT MAY RESULT IN COMPLETE LOSS OF UNIT
FUNCTIONALITY.
In addition to the TOC connectors, the OPS-DRD provides several TOC switches as shown below.
WiFi
1000BT SD
USB
RESET
SERVICE
UBOOT SWITCH
RESET SWITCH
POWER SWITCH