Operation Manual

3
EASY INSTALLATION GUIDE
Part 1 Using the Preinstalled Satellite & Channel list
This receiver is preinstalled with Satellites and default Channels and is fully configured.
No settings need to be changed.
After turning ON the receiver, select a language. Go to system setting and Factory Reset Menu.
If you select Restore default channels, You can use preinstalled default channel list.
How to add/delete Satellites
Press the MENU button on the remote and go to Installation.
Press OK on the Installation setup. Press OK again and a Satellite List will appear.
To add satellites, press the YELLOW( ) button on the remote.
To delete satellites, Press the BLUE( ) button on the remote.
How to setup a DiSEqC 1.3 USALS System
Press the MENU button on the remote. Press OK on Installation. Go to Motorized setup and press
OK.
Go to the Third line(DiSEqC Motor) and use the Left/Right arrow buttons on the remote to select
USALS. Then go to Position Setting and press OK. Then go to Longitude and Latitude and enter
the coordinates of where you live (London’s Longitude is 00.1 West and South of UK’s Latitude is
51.5 North). Press the EXIT button on the remote. Go to GOTO and press OK. Wait until the Signal
Quality is more than 40% in the progress bar. When a satellite is found, then all the selected
satellites are fully configured for a Motorized system.
If the Signal Quality is below 40%, then the settings are incorrect and the Longitude needs to be
adjusted.
For example : 00.2, 00.3, 00.4, 5/6/7/8/9 West or East. The Latitude may also need to be adjusted.
If you still have not got a signal, then the external installation (dish, etc) needs to be adjusted.
How to setup DiSEqC 1.2 Motorized System
Press the MENU button on the remote and go to Installation and press OK. Go to Motorized setup
and press OK. Press OK again to open the satellite list. Select a satellite from the list and press OK.
Go to the Third line(DiSEqC Motor) and use the Left/Right buttons on the remote to select
DiSEqC1.2. Go to Move and press and hold the Left/Right buttons on the remote until you get a
Signal Quality of more than 40%. Go to Command Type and use the Left/Right buttons to select
Save Position.
Then press OK to save. Press the RED( ) button on the remote to scan.
To scan extra satellites, repeat the above.
Part 2 New Installation from start (No Satellites/Channels)
How to do a Factory Reset to Delete the Preinstalled Satellites and Channels
If you want to start the receiver without the preinstalled Satellites and Channels, press the MENU
button on the remote and go to System setting and press the OK button. Go to Factory Reset,
Press OK and enter 0000. Then select Factory Reset and select YES.