Operation Manual

14
USALS System Setup
1. Select USALS on DiSEqC Motor, the USALS menu will
appear.
- Satellite : Select any satellite by pressing ◀/▶ buttons.
- Transponder : Displays the current TP value of the selected
satellite.
- DiSEqC Motor : Select DiSEqC Motor USALS.
- Position setting : set the current degree of the selected
satellite by press OK button
• Longitude degree : set the longitude degree of user
position.
• Longitude direction : set the longitude direction of user
position.
• Latitude degree : set the latitude degree of user position.
• Latitude direction : set the latitude degree of user
position.
- Move Fine : Move the dish position 1 step at a time to
west/east by press ◀/▶ buttons
- Move Control : Control motor by press OK button on the
remote.
• Step Type : Select step size to move by ◀/▶ buttons.
• Move Steps : Move the dish position to west/east by
setting value of step type.
• Limit Set : Control East Limit/Delete Limit/West Limit/Reset System by press OK button.
• East Limit : Set current position to east limit by press OK button.
• West Limit : Set current position to west limit by press OK button.
• Delete Limit : Delete east/west limit by press OK button.
• Reset System : Reset the position of all saved satellites.
- Command Type :
•
Save position : Save the current setting of DiSEqC Motor system.
• Go to position : go the position of the saved satellite by press OK button.
• Go to Reference : Move the dish to the 0 position by press OK button.
• Recalculate : Recalculate the position of all other saved satellites relative to the known
position.
2. Search : Press Red ( ) on the remote to begin satellite search.
3. Auto Navigation : Press Green ( ) on the remote to begin Auto Navigation.
4. Blind Search : Press Yellow ( ) button on the remote to begin Blind Search.
DiSEqC Motor View Control
1. Select DiSEqC 1.2 or USALS in the Motorized Setup menu.
2. In the viewing mode, Press POS button on the remote to
display DiSEqC Motor
- Move : Move the dish position to west/east by pressing ◀/▶
buttons.
- Move Fine : Move the dish position 1 step at a time to
west/east by press ◀/▶ buttons
- Command Type :
• Save position : Save the current setting of DiSEqC Motor
system.
• Go to position : go the position of the saved satellite by press OK button.
• Go to Reference : Move the dish to the 0 position by press OK button.
• Recalculate : Recalculate the position of all other saved satellites relative to the known
position.
3. Press ◀/▶ buttons on the remote to move DiSEqC Motor to get the best signal.