Operation Manual

11
EQUIPMENT CONNECTION
CONNECTION WITH ANTENNA / TV SET / A/V SYSTEM
1. Connect the TV antenna to TV ANT IN.
2. Connect the Video and Audio of TV to the Video and Audio.
Connect Red and White connector to Audio R and Audio L and Yellow into video port
respectively.
3. Connect the Component Video of your TV to Component Video of best quality.
Connect the Y, Pb and Pr of your TV to Y, Pb and Pr respectively.
4. Connect your satellite dish.
* Note : To avoid Slave settop channel’s interference in Master settop channel when
Antenna Loop Through is in use, Please set ‘OFF’ of LNB Power in Installation
setup menu of Slave settop.
* Note : In some receivers TV scart is at the top or bottom of the rear of the receiver.
Please follow the Writing of the TV then connect your scart cable for viewing.