Operation Manual

Through this function, the receiver searches for
all the available channels and saves them in
memory.
- Auto Scan
1. When the Quality is at its highest level, press
the YELLOW( ) button on the remote
control to start scanning for channels.
- Manual Scan
1. Select the channel number or frequency that
you want to search by using the UP/DOWN
buttons on the remote control, manually
enter a frequency.
2. For Bandwidth, choose either 7 MHz or 8MHz
For Search Type, choose from : All Channel,
FTA Only or TV Only.
3. For Network Search, select ON to find the
most channels available. The Strength and
Quality of the signal from the selected
channel is shown by the Level and Quality
indicators at the bottom of the screen.
4. Antenna Supply 5V : Select antenna booster
power ON / OFF.
5. Press the OK button to start scanning.
www.technomate.com
24 25
Your Digital Partner for Life
5. Scan : Press Red ( ) button on the remote to begin satellite search.
6. Add TP : Press Green ( ) button on the remote to add new transponders by
using numeric buttons 0~9 and / buttons on the remote.
7. Delete TP : Press Yellow ( ) button on the remote to delete transponders.
Terrestrial Scan
Edit the information of the current transponder
PID/Audio PID/PCR PID and search the satellite.
1. Press the MENU button on the remote to
display the main menu.
2. Use / and / buttons on the remote to
move in the menu.
3. Select PID Search, then the PID Search menu
will be displayed.
- Satellite : Select a transponder which you want to
search.
- Transponder : Displays the Transponders of the selected satellite.
- Symbol Rate : Displays the current symbol rate list of the selected transponder.
- Polarization : Select Vertical/ Horizontal.
- Video PID / Audio PID / PCR PID : Select and edit by using numeric buttons 0~9 and /
buttons on the remote.
4. Scan : Press Red ( ) button on the remote to begin PID Search.
5. Add TP : Press Green ( ) button on the remote to edit transponder by using
numeric buttons 0~9 and / buttons on the remote.
6. Delete TP : Press Yellow ( ) button on the remote to delete the selected
transponder.
* Note : Setup is now completed. If you cannot see programme after finishing these procedures, please contact your local
dealer.
PID Search
1. For Provider choose either Canal Digitaal or
TV Vlaanderen.
2. For CHs Renumber select ON/OFF
3. Press the Red( ) button.
Fast Scan