User's Guide
Table Of Contents
- Content
- Introduction
- Using the 2173 HF/LF Reader
- Connections
- Micro SD Card
- Software Development
- Troubleshooting and Maintenance
- Regulatory information
- Health and Safety Recommendations
- Waste Electrical and Electronic Equipment (wEEE)
- Warranty
- About TSL®
2173 HF/LF RFID Reader - User Guide V0.04Copyright © 2019 Technology Solutions (UK) Ltd
17
CONNECTIONS
● arrived”)
● Select Action>Reset Bluetooth to SPP mode (wait for the process to complete)
● Disconnect the HF/LF reader from the computer (unplug USB)
● Wake the HF/LF reader (pull trigger, blue flashing LED)
● Pair to the reader on the device
(*) if not download from here
http://www.ftdichip.com/Drivers/VCP.htm
FURTHER INFORMATION
Further information can be found from the Reader Download pages (free, one-time, registration required - see links
above)
Application Note – Bluetooth
®
HID mode
: Provides further examples for configuring HID mode
Application Note – Using the Micro SD log and auto-run files
: Describes using the AUTO.TXT
TSL ASCII Protocol 2.4 Rev B
: Details all the commands including for HID .st,.hs,.hc, and .hd
If you encounter any issue while following the above procedure please contact
support@tsl.com
providing the
following information:
● The serial number of the HF/LF Reader
● The Firmware version of the HF/LF Reader
● The step at which the procedure failed
● A description of the fault that occurred
i
Firmware requirements: 1128 - v4.2.7 or greater; 1153 – v2.1.7 or greater; 1166 – v1.1.6 or greater
www.tsl.com