Product Card

Biometric Accessory Approvals Application
This application is used to set the accessory into various modes. As the application is launched it detects
the presence of the hardware. Once detected the mode buttons are enabled.
NOTE: For the accessory to change to some modes an RFID card must be present in the field. A card has
been provided for this purpose. It is only required to change the mode. The current mode is displayed
on the screen. Any errors are displayed in the list view below the buttons.
NOTE: To enter the “On, Carrier only” state is it best to set the mode to off and then set the mode to
“On, Carrier only” rather than switch directly from the other modes.
Tap the appropriate button to set the hardware into the required mode:
OFF – Turns of the accessory
ON, NO RF – Powers up the accessory and then powers of the contactless card reader
ON CARRIER ONLY – Powers up the accessory and sets the RF field into a continuous carrier only mode
ON ACTIVE – Powers up the accessory and sets the RF field so that the reader is searching for
transponders
Use the left soft menu key to exit the application.