User's Manual

Multi ISO RFID 1059 User Guide.doc 1059
Page 10 of 22
5.4 Fitting a SAM
To fit a SAM it is necessary to remove the cover of the RFID 1059. This must
only be done in an ESD safe area with appropriate precautions to avoid the
possibility of damage to the RFID 1059.
Remove the four Pozidriv screws securing the front cover:
Figure 5: Location of cover fixing screws
Remove the front cover by pulling it away from the body of the RFID 1059,
starting at the docking connector end.
The SAM socket is unlocked by sliding the metal cover towards the MC70
mating connector:
Figure 6: Unlocking the SAM socket
Remove four screws.