User's Manual

Page 42
Refer all servicing of this product to qualified
service personnel. Do not attempt to service
it yourself, as opening or removing covers
may expose you to dangerous voltage points
or other risks.
Susceptibility to Interference:
There may be temporary degradation of the
image when Prodigi is subjected to a strong
radio-frequency field, electro-static discharge
or transient electrical noise. An electro-static
discharge (caused by static electricity) may
cause the screen to go blank. If this happens,
power the system off and on again.
Warning RF Exposure Compliance:
The antenna(s) used for this transmitter must
be installed to provide a separation distance
of at least 1 cm from all persons and must not
be co-located or operating in conjunction with
any other antenna or transmitter. Users and
installers must be provided with antenna
installation instructions and transmitter
operating conditions for satisfying RF
exposure compliance.
Page 43
FCC / Industry Canada Two Part Stmt:
This device complies with FCC Part 15 and
Industry Canada license exempt RSS
standard(s). Operation is subject to the
following two conditions: (1) this device may
not cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
Per Industry Canada RSS rules:
This device complies with Health Canada’s
Safety Code. The installer of this device
should ensure that RF radiation is not emitted
in excess of the Health Canada’s
requirement. Changes or modifications not
expressly approved by the party responsible
for compliance could void the user’s authority
to operate the equipment.
FCC Warning:
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the Federal
Communications Commission (FCC) Rules.