User's Manual

Page 34
Recharging the battery:
Press and hold the Back button to display the
Tablet’s battery status. If the battery charge
level is below 10%, it is recommended that
you recharge the battery.
To recharge the battery using mains
electricity:
Connect the USB Recharge Cable to
the Tablet Power Supply. Then,
carefully connect the USB Recharge
Cable to the Tablet and plug the Power
Supply to an outlet.
Let the Tablet recharge for 8 hours the
first time and for 4 hours subsequently.
To recharge the battery with a computer:
First, press Power shortly to enter
Standby Mode.
Then, plug the USB recharge cable to a
computer USB port.
Note: Please note that recharging the
battery this way can take longer than by
plugging it to an outlet.
Page 35
Press Power to exit Standby Mode.
IMPORTANT: The battery becomes warm
during recharging. Do not recharge the
battery near a heat source.
Replacing the battery:
Contact HumanWare or your authorized
distributor to obtain a replacement battery.
Power off the Tablet and unplug it from
the outlet.
Hold the Tablet up, its back side facing
you.
Press the release button near the left
edge of the Tablet, and simultaneously
slide the compartment door to the left to
remove it.
The battery’s upper left edge has a tab.
Use this tab to lift the used battery up.
Note: The model and serial numbers
can be found under the battery.
To insert the new battery: there are
connector pins on the lower right edge
of the battery. Insert the right edge first,