User's Manual

BrailleNote Apex QT User Guide
11-273
4. If using a dial-up modem to access your e-mail, read this. If not, skip to the next step. KeySoft
displays the message “dialing,” and you should hear the dialing process followed by whistling
noises as your modem connects with the modem at your Service Provider. Before the sequence
of messages listed in the next step, you will first hear these:
Dialing;
Connected;
Logging On;
Logon Successful;
Connected;
...and at the end of the sequence below, you will get this message:
Remain connected to the modem? (Press Y or N)
5. KeySoft reports the progress of the mail checking sequence by displaying the appropriate
message as each significant stage of the operation is completed. The typical sequence of
messages, assuming you have one new message to receive and no outgoing e-mail to send, is:
There is 1 e-mail on Server;
Checking for new messages;
There is 1 new e-mail;
Receiving 1;
There is no e-mail to send.
For details on the options available while downloading e-mail, during the download options, refer to
the following section 11.9.1 Download status.
During the sending and receiving process BrailleNote QT beeps once every few seconds indicating
it is busy.
When using a dialup connection, at completion of sending your messages, KeySoft displays
"Remain connected to modem?" To disconnect and return to the KeyMail Menu, press N. To
remain connected and return to the Main Menu, press Y.
If you wish to terminate the e-mail session at any time, press ESCAPE. If using a dial-up
connection, KeySoft will prompt, "Abandon e-mail session after current operation or hang-up
immediately?". To allow KeySoft to compete its current operation before hanging up, press N for
no. To hang up immediately, press I for immediately.