User's Manual

BrailleNote Apex QT User Guide
6-137
6.7.1 Use Form Feeds Between Pages.
The factory setting for this item is Yes.
6.7.2 Pause After Each Page.
For automatic sheet feeding or continuous stationery, leave this item at the factory setting of No. If
you have to feed individual sheets into the embosser, you should set it to Yes. When you are
actually using the embosser, load a new sheet when prompted to do so, and press ENTER to
continue.
6.7.3 Does Your Embosser Emboss Both Sides of the Page.
If your embosser embosses both sides of the paper, you should set this item to "Yes". Otherwise,
leave it set to the factory setting of "No." If you want to emboss a particular document single-sided,
the appropriate setting should be changed in the Document Layout list, not here. This is described in
7.17.9 Layout of a Braille Document.
6.7.4 Page Offset.
This defines the position of the left margin of the embossing, in cells from the left edge of the
paper. It is like an overall left margin which affects all embossing. The factory setting is zero.
Values from 0 to 50 are allowable.
6.7.5 Embosser Braille Table.
Following the prompt: "Embosser braille table?", press CONTROL with SPACE to step through
the available tables, for example, KeySoft 6-dot English Embosser. Press ENTER to make your
selection.