User's Guide

HumanWare

www.humanware.c

TREK

User Guide

revision 10-2019/07/17

Note regarding Route configuration: You can directly access Route Settings. To do so, press the

Go To button, select the desired route, then, press 3. The following options are made available:

- Rename Route

- Delete Route

9.15.3.1 Renaming Route:

Upon selecting this option, a beep will prompt you to dictate the new name for the route in

question. After 4 seconds, recording ends with a beep and message. The system exits

configuration mode and announces the current state.

9.15.3.2 Deleting Route:

Upon selecting this option, the system prompts you to delete the selected route. Press Confirm

to Delete. Upon doing so, the system exits configuration mode and announces the current state.

9.15.4 Import and export

Upon selecting this option, the system will ask you to select either a Landmark or Route.

9.15.4.1 Landmarks

Export landmarks to SD card

Selecting this item will export all your saved landmarks to the $TREKLandmarks folder of your SD

card.

Import landmarks

Selecting this item will import all landmarks found in both the root and the $TREKLandmarks

folder of your SD card.

Delete all landmarks

Selecting this item will delete all landmarks saved on your device. If you are sure you wish to

delete all landmarks, confirm by pressing the Confirm key.

9.15.4.2 Route

Export routes to SD card

Selecting this item will export all your saved routes to the $TREKRoutes folder of your SD card.

Import routes

Selecting this item will import all routes found in both the root and the $TREKRoutes folder of

your SD card.

Delete all routes

Selecting this item will delete all routes saved on your device. If you are sure you wish to delete

all routes, confirm by pressing the # key.

9.15.5 Configuring Verbosity

Use the arrows to select which verbosity option you wish to modify. There are five verbosity

options: Point of interest verbosity, Route information Verbosity, Where am I verbosity,

Intersection verbosity, and Reset verbosity defaults. Press Confirm to select the verbosity option

of your choice.