User's Guide

HumanWare
www.humanware.c
om
TREK User Guide
65
revision 10-2019/07/17
Voice Auto-switch
About
Reset Pedometer
Reset GPS position
Update GPS satellite positions
Press Confirm to select an option.
Press Explore Star or press 7 at any moment to exit the Settings menu.
9.15.1 Turning GPS on
Use the arrows to turn the GPS on or off. Confirm your selection by pressing the Confirm button.
Note that turning the GPS off when you are not using it can preserve your battery life.
9.15.2 Configuring Landmarks
Use the arrows to select the landmark you wish to configure.
Press Confirm to load the selected landmark
Use the arrows to select the operation you wish to perform on the landmark. Operations include:
Rename, Set/Unset as destination and delete.
Press Confirm to trigger the selected operation.
Note regarding Landmark configuration: You can directly access Landmark Settings. To do so,
press and hold the Go To button, then select a landmark and press 3. The following options are
made available:
- Rename landmark
- Unset landmark as a possible destination
- Delete landmark
9.15.2.1 Rename Landmark:
Upon selecting this option, a beep will prompt you to dictate the new name for the landmark in
question. After 4 seconds, recording ends with a beep and message. The system exits
configuration mode and announces the current state.
9.15.2.2 Set or Unset Landmark as possible destination:
Upon triggering this option, the system will ask you to set or unset the current landmark as a
possible destination. Press Confirm to set or unset the landmark as a destination. Upon doing
so, the system exits configuration mode and announces the current state.
This operation can also be achieved while you are recording your landmark.
When recording the landmark. Press Confirm within 30 seconds after its creation. Trek will
confirm that the landmark has been unset as a possible destination.
9.15.2.3 Delete Landmark:
Upon selecting this option, the system prompts you to delete the current landmark selected.
Press Confirm to Delete. Upon doing so, the system exits configuration mode and announces
the current state.
9.15.3 Configuring Routes
Use the arrows to select the route you wish to modify.
Press Confirm to load the selected route. Use the arrows to select the operation you wish to
perform on the route. Operations include: Rename and delete.
Press Confirm to trigger the selected operation.