User's Guide

ManualsBrandsTechnologies Humanware ManualsElectronicsWireless Transmitter with Qualcomm WCN3630 Chip

HumanWare

www.humanware.c

TREK User Guide

revision 10-2019/07/17

3. When the system has confirmed that you are creating a route, navigate the entire course

of the route. Trek will emit a beep every 60 seconds to indicate the recording of the route.

If GPS coverage is lost along the way, a message will inform you and beeping will stop.

When GPS coverage is found again, beeping resumes.

4. Note that you can create landmarks along the way. To do so, press the Record button.

After the beep, you will have 4 seconds to provide a vocal description of the landmark. A

double beep will indicate the end of the landmark creation, at which point you can

continue your route.

5. When you have reached your destination, press and hold the Record button until you

hear the beep, to inform the system that the destination has been reached. The beeping

stops and a message informs you that Route recording has ended.

Note: On occasion when creating a route, the system will announce the wrong intersection. This

occurs when parallel streets are close to each other. If you know that the current intersection

announced is wrong, press the Confirm button. You will be asked if you wish to delete this

intersection from your route. Press Confirm again to delete the intersection. The system will fill in

the gap to complete the route.

Important: You cannot record routes when in a vehicle. If you enter a vehicle during the route

creation, please note that that your route may not be valid. Please preview before using this

route. If you create a route while in a vehicle, the Trek will return to pedestrian mode and will

announce "Warning, this route will be created for pedestrian travel."

9.8.2 Indoor Preview of a route

Trek allows you to preview a route before navigating it. This gives you a chance to learn the route

instructions ahead of time. Indoor preview will provide you with detailed intersection information

and turn instructions.

To preview a route indoors without being interrupted by GPS information:

1. Activate the route. To do so, press and hold the Go To button and use the left and right

arrows to browse among available routes. When the route you are looking for is

announced, press Confirm to load the route in the system.

2. You will be asked if you wish to preview the route in Forward direction or in Reverse.

Press Confirm for Forward, or Press and Hold Confirm for Reverse.

3. Press and hold the Left or Right arrow. Trek will announce you are in the Indoor Preview

mode followed by the first instruction.

4. You will be able to navigate through all instructions using the Left and Right arrows

without being interrupted by incoming GPS information.

5. To exit Indoor Preview, press and hold the Left or Right arrow or press Confirm.

9.8.3 Activate a Recorded Route

You can use Trek to guide you along a previously recorded route.

To select a route:

1. Press and hold the Go To button located at the top left corner of the front panel.

2. Use the left and right navigation arrows to browse among available routes.

3. When the route you are looking for is announced, press Confirm to select it.

4. Press Confirm to be guided in forward direction. You will be given instructions on the

direction to take to begin your route. If you wish to travel the route in Reverse, press and

hold the Confirm button.