User's Guide

HumanWare
www.humanware.c
om
TREK User Guide
57
revision 10-2019/07/17
Search by Category
If you selected Search by Category, you will be able to refine your search of points of interest by
selecting a category from the list. Once again, use the arrows to browse the list of points of
interest found, and press Confirm to select a destination. You will also need to confirm whether
this is a pedestrian or automotive route.
The list of categories is as follows:
"Landmarks"
"Transportation"
"Food"
"Banking"
"Health"
"Shopping"
"Lodging"
"Education"
"Public Administration"
"Automotive"
"All"
Note that if you do not press Confirm on a given landmark / point of interest or Category within
30 seconds, the system will exit the What's around feature and will return to Explore mode.
Search by Name
If you selected Search by Name, simply type in a name of your destination using the numeric
keypad, then press Confirm. You don’t have to type the complete name to begin the search. For
more information on how to type using the numeric keypad, please refer to section 5.1 of the User
guide.
Once you are done typing, press Confirm. The Trek will then provide you with a list of up to 50
points of interest found within a range of 5 miles (8 km) that contains the partial name entered.
Use the arrows to select the point of interest of your choice, and Confirm to select a destination.
You will also need to confirm whether this is a pedestrian or motorized route to begin instructions.
9.6.3 Next instruction or Next Intersection
When on an active route, you can preview the next instruction by pressing the Right arrow. Trek
will announce the distance to the next instruction followed by the action to be taken. Each time
you press the Right arrow the Trek will announce the following instruction. Use the Left arrow to
navigate previous instructions. To return to guidance, press Confirm at any moment. When in
Explore mode, pressing the Right arrow will announce the next intersection you will encounter if
you continue in the same direction.
9.6.4 Pedometer
Pedometer data provides the following information: Walking distance after Trek was activated,
Walking time (does not include time where no movement is detected) and Average walking
speed.
To access Pedometer data, press the Information button, then press Right arrow twice.
To Reset Pedometer data, go to the Settings menu.