Specifications

Minutes flashing
Hour flashing
To set the time display:
1. Press and hold the SET key at the front of the Weather Station about four seconds to enter the set mode
2. The hour digit starts flashing. Use the “+” key to enter the hour.
3. Press the SET key to enter the minutes. The minute digits start flashing.
4. Press the “+” key to set the minutes.
5. Press the SET key or avoid touching any keys for eight seconds to confirm the time setting.
USING THE WEATHER STATION:
WEATHER FORECAST AND WEATHER ICONS:
The weather forecast and icons can display three weather symbols and two weather tendency indicators in forms of
an arrow. The arrows will change their appearance depending on the air pressure development.
INDOOR TEMPERATURE:
The indoor temperature is displayed on the LCD under the time. The Weather Station’s built in sensor automatically
measures the temperature once the batteries are inserted.
MINIMUM AND MAXIMUM INDOOR TEMPERATURE RECORDINGS:
By pressing the “MIN/MAX” key the current indoor temperature will alternate between the maximum, minimum, and
current temperature recordings (also changes for outdoor temperature). Once a new indoor temperature high or low is
reached, it will automatically set into the Weather Station’s memory.
Note: When current temperature is selected, the MAX or MIN icon will not appear on the LCD.
OUTDOOR TEMPERATURE READING:
The outdoor temperature reading is on the bottom part of the LCD. The Weather Station receives the outdoor
temperature via 433 MHz frequency when the batteries are inserted into the transmitter within the 1-1/2 minutes of the
setting up time (See Setting up above).
Note: Should the outdoor temperature not be received within 2 minutes after inserting the batteries into a transmitter,
then see “Checking 433 MHz reception” below.
MINIMUM AND MAXIMUM OUTDOOR TEMPERATURE READING:
By pressing the “MIN/MAX” key the current outdoor temperature will alternate between the maximum, minimum and
current temperature recordings. Once a new outdoor temperature high or low is reached, it will automatically be set
into the Weather Station’s memory.
Note: When current temperature is selected, the MAX or MIN icon will not appear on the LCD.