Instruction manual

BATTERY CHANGE:
s of the temperature station when the battery low indicator is displayed at the User shall replace batterie
LCD. If user does not replace batteries, working error may be resulted.
Note:
After changing batteries in temperature station, there is no need for user to reset the temperature
ff
ease participate in the preservation of the environment. Return used batteries to
station. In fact, the temperature station can remember all transmitter information and sequence as
per the pervious set-up. However, user may require to reset the desired LCD contrast, Alarm On/O
condition and the Clock (by re-entering the date and time manually or simply wait for the DCF time
signal).
The “Average” value display for particular channel will only be calculated from the data after battery
change.
User needs to carry out the re-learning of the particular transmitter after replacing batteries to it. See
“LEARNING/ REMOVING A TRANSMITTER (CHANNEL)” for the procedures of relearning a
transmitter.
It is recommended to replace the batteries in all units on an annual basis to ensure optimum
accuracy of these units.
Pl
an authorized depot.
47