manual

WS 8009 - Radio controlled wall clock

Instructions manual

Part A Part B Part D

A1: Radio controlled time B1: “SNOOZE” button Wall mount hole

A2: Temperature B2: “MODE” ”SET” button Stand

A3: Date and day of week B3: “+” “12/24H” button Battery compartment

A4: Radio controlled icon B4: “-” “C/F” button

A5: Alarm icon B5: “ALARM ON/OFF” button

A6: Humidity

Set up and radio controlled time:

• Insert 3 x C batteries (not included) by observing the correct polarity signs (+/-) inside the battery

compartment.

• After inserting the batteries, the clock automatically starts scanning the DCF frequency signal after

new batteries inserted (“

” flash on the LCD).

“

” flash indicate DCF signal searching.

“

” indicate signal received successfully.

“DST” icon will turn on when the DCF have DST signal in it.

• The clock automatically scans the time signal at 3:00a.m. everyday to maintain accurate timing. For

failed reception, scanning stops (on the LCD disappear) and repeats again at 4:00a.m., 5:00a.m.,

6:00a.m.

• The clock manually scans the time signal by holding “ ” (B4) buttons for 2 seconds. For failed

reception in 10 minutes, scanning stops (“

” on LCD disappear). And repeats again in the next hour.

e.g. if scanning at 8:20a.m. fail, it will scan again at 9:00a.m.

• Hold “ ” (B4) buttons for 3 seconds to stop scanning.

Notes:

• Remove batteries and then insert batteries again to reset the unit if it does not work properly.

•

Avoid placing the clock near interference sources/metal frames such as computer monitor or TV sets.

• Buttons will not function while scanning for DCF time signal unless they are well received or stopped

manually.

• Never use the clock in bathroom or any other area with high humidity

• The clock loses its time information when the battery is removed.

Manual time setting

1. Hold “MODE” button (B2) until Hour digit flashes.

2. Press “+” (B3) or “-” (B4) button to adjust Hour, Minutes, Second, Year, Month/Day sequence, Month,

Date, Weekday Language, Time Zone.

3. Press “MODE” button (B2) to confirm each setting.

PAGE 1
WS 8009 - Radio controlled wall clock Instructions manual Part A A1: Radio controlled time A2: Temperature A3: Date and day of week A4: Radio controlled icon A5: Alarm icon A6: Humidity Part B B1: “SNOOZE” button B2: “MODE” ”SET” button B3: “+” “12/24H” button B4: “-” “C/F” button B5: “ALARM ON/OFF” button Part D Wall mount hole Stand Battery compartment Set up and radio controlled time: • Insert 3 x C batteries (not included) by observing the correct polarity signs (+/-) inside the battery compartment.
PAGE 2
Notes: • There are 8 languages, English, German, French, Spanish, Italian, Dutch, Denmark and Russian for day-of-week-display. The languages and their selected abbreviations for each day of the week are shown in the following table.
PAGE 3
• • • • • • • Never mix used and new batteries. Remove exhausted batteries immediately. Remove batteries when not in use. Do not recharge and do not dispose of batteries in fire as the batteries may explode. Ensure batteries are stored away from metal objects as contact may cause a short circuit. Avoid exposing batteries to extreme temperature or humidity or direct sunlight. Keep all batteries out of reach from children. They are a choking hazard.