Specifications

POSITIONING
Weather Station:
The Weather Station comes complete with a detachable stand that gives the option of table
standing or wall mounting. To wall mount:
1. Fix a screw into the desired wall, leaving the head extended out by
about 5mm.
2. Using the Weather Station’s hanging hole, carefully hang it onto the
screw.
Note:
Always ensures that the unit locks onto the screw head before releasing.
Outdoor Transmitter:
The Outdoor Transmitter is supplied with a holder that may be attached to a wall with the
three screws or double-sided tape supplied.
To attach to the wall using screws, please follow the steps below:
1. Mark the wall using a pen through the holes in the holder to
obtain the exact drilling position.
2. Drill holes in the wall at the points marked.
3. Screw holder onto wall.
The Outdoor Transmitter simply clicks in or out of the holder. When inserting or removing
the Outdoor Transmitter to or from the wall holder please hold both units securely to avoid
tearing the holder from the wall.
There is also double sided tape included with the wall holder. On smooth surfaces this can
be used instead of drilling holes. The mounting surface can, however, affect the
transmission range. If for example the unit is attached to a piece of metal, it may then either
reduce or increase the transmitting range. For this reason, we recommend not placing the
unit on any metal surfaces or in any position where a large metal or highly polished surface
is in the immediate proximity (garage doors, double-glazing, etc.). Before securing in place,
please ensure that the Weather Station can receive the 433 MHz signal from the Outdoor
Transmitter at the positions that you wish to situate them.