Specifications

Minimum and maximum indoor temperature recordings:
By pressing the “MIN/MAX” key the current indoor temperature will alternate between the
maximum, minimum, and current temperature recordings (also changes for outdoor
temperature). Once a new indoor temperature high or low is reached, it will automatically
set into the Weather Station’s memory.
Note:
When current temperature is selected, the MAX or MIN icon will not appear on the
MAX/MIN section of the LCD.
Outdoor temperature reading:
The outdoor temperature reading is on the bottom line of the LCD under MIN and MAX
icon. The Weather Station receives the outdoor temperature via 433 MHz frequency when
the batteries are inserted into the transmitter within the 1-1/2 minutes of the setting up time
(See Setting up above).
Note:
Should the outdoor temperature not be received within 2 minutes after inserting the
batteries into a transmitter, then see “Checking 433 MHz reception” below.
Minimum and maximum outdoor temperature reading:
By pressing the “MIN/MAX” key the current outdoor temperature will alternate between the
maximum, minimum and current temperature recordings. Once a new outdoor temperature
high or low is reached, it will automatically be set into the Weather Station’s memory.
Note:
When current temperature is selected, the MAX or MIN icon will not appear on the
MAX/MIN section of the LCD.
Resetting the minimum and maximum temperature recording:
By pressing and holding down the “MIN/MAX” key for about 3 seconds, both the indoor and
outdoor minimum and maximum temperature recordings will be reset to the current indoor
and outdoor temperatures.
Important Note:
All the outdoor temperature recordings (max/min in all existing channels) will be reset at the
same time.
Outdoor temperature 1, 2, and 3
If the more than one transmitter is being used, to alternate between the temperature
readings of transmitter 1, 2, and 3, simply press the “CH” key. If the reading is from
transmitter 1, then the channel identification number 1 will be displayed in the outdoor
temperature section of the LCD. The same will apply to the next transmitter and so on.
However, if only one transmitter is used, no identification number will be displayed on the
LCD.