INSTRUCTION MANUAL OF WS 6720 Wireless Indoor and Outdoor Weather Station P.
QUICK START 1. Slide open the battery cover at the back of your wireless thermometer-clock. 2. Insert 2 x AAA batteries into the battery compartment by observing the correct + / - polarity signs inside the battery compartment. 3. Replace the battery cover. In few seconds the LCD shows the default time, calendar and the current indoor temperature and it starts to search for outdoor temperature signal. 4. Then insert 2 x AA batteries into the outdoor sensor.
1. 2. icon keeps flashing. The alarm will Press SNOOZE once to stop the alarm temporarily, the beep again in 5 minutes. To stop the alarm, press / CHANNEL (ALM On-Off) once, the alarm beep will stop and the icon become static, alarm will beep again same time next day. Alarm Duration : 2 minutes TO DISPLAY TEMPERATURE IN DEGREE °C OR °F (°C/°F) to display temperature in degree C or degree F.
After your weather station is powered up, it will take around 24 hours to get stable. The weather icons on the display give a reference to the next 6-12 hours weather conditions. It may not match with the current weather condition outside. TO SYNCHRONIZE YOUR CLOCK WITH MULTIPLE OUTDOOR SENSORS Your wireless thermometer-clock is equipped with one outdoor sensor. You could purchase second or third outdoor sensor to work with this thermometer-clock at the same time. 1.
Words in the figure: Figure English FRONT VIEW PM INDICATOR TIME DATE / MONTH MAXIMUM / MINIMUM ICONS LOW BATTERY OF OUTDOOR SENSOR SET / ALARM / (°C/°F) MAX / MIN RESET / CHANNEL (ALM ON-OFF) SNOOZE OUTDOOR TEMPERATURE WIRLESS TRANSMISSION ICON RF SENSOR CHANNEL WEATHER FORECAST ICONS ALARM ON BACK VIEW WALL HANGER HOLE INSERT 2 X AAA BATTERIES SIDE VIEW FOLDING STAND OUTDOOR TEMPERATURE SENSOR RESET INSERT 2 X AA BATTERIES Quartz clock 12 / 24 h display Date display Indoor and outdoor temperature in °C o
