Specifications

8. Function test:

Once the weather station is powered up, perform a function test by

checking that the weather data is received. To do this, press the

either DISPLAY, PRESSURE or WIND keys to toggle through the

relevant LCD sections:

1) Indoor temperature and humidity

2) Outdoor temperature and humidity

3) Outdoor wind chill

4) Dew point

5) Rainfall 24 hour

6) Rainfall 1hour

7) Rainfall Total

8) Relative and absolute pressure

9) Wind speed, wind direction and wind direction in degrees

If any readings cannot be received from the sensors, lines (- - -) will

be displayed in the respective weather sections of the LCD. In this

case, check that all cables are correctly inserted into the correct

sockets and press and hold the PLUS(+) key for 2 seconds and a

short beep will sound to synchronize the base station to the sen-

sors otherwise no weather data will be received.

Some weather readings such as wind speed and direction may not

appear immediately on the LCD if the wind-fan or vane of the wind

sensor is moved. This is due to the set reading time intervals for

the wind readings. However the current wind speed or direction will

be displayed once the time reading interval is reached. For rainfall,

the interval readings may take up to 2 minutes before the data is

displayed on the LCD.

9. Mounting

Important Note

Prior to drilling mounting holes and permanently affixing any of the

units, please ensure the following points are considered:

• Cable lengths of the units meet with your distance require-

ments at the point of fixing