Operation Manual

RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 6.9
(4) As for point (1) but on pin 1 and 2 of the patch connector CN5.
(5) As for point (1) but on pin 0 and 1 of the relay.
(6) Place the tester probes between pins 6 and 8 of the relay. The measured voltage should be 0
Ohm.
(7) Place the tester probes between pins L1 and N of the inverter. The measured voltage should be
220 VAC.
Downloaded from www.Manualslib.com manuals search engine